Care And Cleaning - RUSTA 900701260101 Gebrauchsanweisung

ENG
• To crush ice, add up to 6 ice cubes. If more ice is needed, remove the cup and add
cubes one by one through the lid opening.
NOTE! Do not run the appliance for more than 3 minutes per time, and wait until the
unit has cooled to room temperature before performing the next operation cycles.

CARE AND CLEANING

This product does not contain any parts that the user can repair on their own. For service,
contact the manufacturer, its service agent or a similarly qualified person.
1. Before cleaning, unplug the blender.
2. Always wash immediately after use for easier cleaning. Do not let food dry on the jar
assembly, as this will make cleaning difficult.
3. Pour a little warm soapy water into the jar and turn the knob to P position for a few
seconds. Then empty the jar.
4. Dismantle all detachable parts. Lift the jar assembly off the motor unit. Detach
the blade assembly by turning it clockwise from the jar base bottom. Remove the seal
ring 2 and blade assembly (see fig. 6). In addition, detach the jar cover seal ring 1 from
the jar cover.
5. Rinse the measuring cup, lid, seal ring 1, jar unit, seal ring 2 and blade assembly by
hand or in a dishwasher and then dry. These parts are dishwasher safe up to 65°C.
6. Brush the blade clean using warm soapy water, then rinse thoroughly under the tap.
Do not touch the sharp blades. Handle carefully. Do not immerse the blade assembly
in water. Leave to dry upside down away from children.
7. Wipe the motor unit with a damp cloth and dry thoroughly. Remove the stubborn spots
by rubbing with non-abrasive cleaner. If liquids spill into the motor unit, first unplug
the unit, then wipe with a damp cloth and dry thoroughly.
CAUTION!
• Do not immerse the motor unit in liquid to prevent the risk of electric shock.
• Do not use rough scouring pads or cleaners on parts or finish.
6
Fig 6