Once having put in function this mode the clock cannot be stopped by pushing any button
unintentionally. The elapsed - time - mode can only be stopped by pushing buttons
at the same time. The display will show in this case four horizontal dashes. The same effect
you can reach naturally with the
3. Local - Time - Mode
This mode allows you to set the clock on any completed minute to corresponding minute of
the local - time.
1. Switch on
The button
B
minute-digit.
The button
C
raises the digit by one. The button
Count - Down - setting. The third dot disappears.
The button
B
counts backward the minutes adjusted on the clock. A
short appearance of four dots at the bottom confirms
the correct start of this function.
After reaching the zero-time the clock shows the time
counting upward. In this example 44 seconds.
On/Off - switch
( the display will be empty ).
2. Push the button
5
changes the ten- minute-digit to the
reduces the digit by one, the button
starts the Count - Down. The clock
A
3. Push the button
D
A
concludes the
B
und
D
A