Once having put in function this mode the clock cannot be stopped by pushing any button
unintentionally. The elapsed - time - mode can only be stopped by pushing buttons
at the same time. The display will show in this case four horizontal dashes. The same effect
you can reach naturally with the
2. Elapsed - Time - Mode with Count - Down - Function
This mode allows you at - maximally 59 minutes prior take-off - to start the Count - Down -
function. The time will be counted backward. When reaching the take-off - time the display
shows 00:00. Thereafter the elapsed - time will be presented on the display. Every fifteen
seconds the time will be announced during all operations.
For example: 49 minutes before take-off for a navigation-flight you want to make the l a st
checks. Count-Down-Setting should be 49 minutes.
1. switch on
The first three steps show correct function of the display.
On/Off - switch
( the display will be empty ).
2. Push button
A
Push again button A.
When pushing button
colon which
a) shows you the digit, that can be set;
b) confirms the use of the Count - Down - Function.
Activating the button
between the two digits representing minutes-display.
The button
C
pushing the first time. Every repetition of pushing
will reduce the digit by one. The button
digit by one but not more than 5.
4
3. Push again button
B
a third dot appears below the
B
the decimal dot changes
sets the ten-minutes-digit on 5 when
B
und
D
A
C
D
raises the