Length Adjustment - Jay J2 Gebrauchsanweisung

E N G L IS H
Fig.8.0
1 2
5
Figure 8.0 labels:
1. A strong platform base promotes level sitting surface.
2. Five, hook attachment locations accommodate most
wheelchair frames.
3. Drop Hooks can be used to change the seat to floor
height. Available in; 12.7 mm, 25.4 mm, 38.1 mm,
(1/2", 1",1-1/2"), sizes.
4. The cushion is notched to allow for a drop of up to
38.1 mm, (1-1/2").
5. Each hook can be slide adjusted up to 12.7 mm,
(1/2"), to allow for slight differences in wheelchair
widths.
SECURE HOOK RETAINERS AND STOPPER KIT
To secure the restraining hardware onto your wheelchair
rails:
6. Snap the two hook retainers toward the back of the
wheelchair seat rail.
7. The rear hooks will slide under these as shown below.
These will prevent your cushion from accidentally
popping out of the wheelchair.
8. Snap the hook stopper towards the front of the
wheelchair seat rails.
9. The front hooks rest behind the stopper to prevent
your cushion from sliding forward.
10. Retainers and stoppers should be secured tightly to
wheelchair seat rails with the nuts and bolts provided.
11. Point the heads of the bolts to the outside of the
wheelchair.
J2 & J2 DC
CAUTION:
Enclosed are three lengths of 8-32" bolts. Using a bolt
longer than the required length can interfere with installation
and removal of seat.
Use the following sizes contained in the kit:
• 8-32 x 3/4" when the stopper and/or retainers are
mounted on 7/8" tubing.
• 8-32 x 1" when the stopper and/or retainers are mounted
on 1" diameter tubing.
• 8-32 x 1-1/4" when the stopper and/or retainers are
mounted over "rivnut" threaded insert on 1" diameter
tubing.
3
• To install cushion, simply slide rear hooks under the
rear hooks retainers and drop front hook behind hook
stopper.
Note: If hook retainers or stopper cannot be installed due to
4
interference with hardware on your wheelchair, you might
need to select an alternate location for your brackets and
hooks.
Fig.9.0
Figure 9.0 labels:
A = Use hook stoppers 1/4" forward of the front hooks.
B = Use hook retainers behind rear hooks.

Length adjustment:

For a longer seat length, position Solid Drop Seat 25.4 mm
(1") forward of the rear vertical posts of your wheelchair.
If front hooks are less than 25.4 mm (1") from front end of
seat rails, then remove front hooks and move them to the
alternate location directly behind (see picture).
Fitting Hints:
Once you have determined the position of your Solid
Drop Seat on your wheelchair, you may find that the
hooks interfere with the hardware that is particular to your
wheelchair. If this is the case, reposition those particular
hardware hooks to an alternate location.
14
INSTALLATI ON / AD JU ST MENT
A B
EU=Rev.1.0