Dust/Chip Extraction; Starting Operation; Working Advice - Bosch GWS 18 V-LI Professional Originalbetriebsanleitung

OBJ_BUCH-1102-002.book Page 32 Wednesday, November 4, 2009 3:23 PM
32 | English

Dust/Chip Extraction

Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Operation

Starting Operation

Inserting the Battery
Use only original Bosch lithium ion batter-
ies with the voltage listed on the nameplate
of your power tool. Using other batteries can
lead to injuries and pose a fire hazard.
Insert the charged battery 4 from the front into
the base of the power tool until the battery is se-
curely locked.
Switching On and Off
To start the power tool, push the On/Off switch
2 forwards.
To lock the On/Off switch 2, press the On/Off
switch 2 down at the front until it latches.
To switch off the power tool, release the On/Off
switch 2 or, if it is locked, briefly push down the
back of the On/Off switch 2 and then release it.
1 609 929 U65 | (4.11.09)
Check grinding tools before using. The
grinding tool must be mounted properly
and be able to move freely. Carry out a test
run for at least one minute with no load. Do
not use damaged, out-of-centre or vibrating
grinding tools. Damaged grinding tools can
burst and cause injuries.

Working Advice

Clamp the workpiece if it does not remain
stationary due to its own weight.
Do not strain the machine so heavily that it
comes to a standstill.
After heavily straining the power tool, con-
tinue to run it at no-load for several minutes
to cool down the cutting/grinding tool.
Grinding and cutting discs become very hot
while working; do not touch until they have
cooled.
Do not use the power tool with a cut-off
stand.
When the power tool is electrostatically
charged, the built-in electronic control switches
it off. To restart the power tool, press the
On/Off switch 2 again.
Rough Grinding
Never use a cutting disc for roughing.
The best roughing results are achieved when
setting the machine at an angle of 30° to 40°.
Move the machine back and forth with moderate
pressure. In this manner, the workpiece will not
become too hot, does not discolour and no
grooves are formed.
Flap Disc
With the flap disc (accessory), curved surfaces
and profiles can be worked.
Flap discs have a considerably higher service
life, lower noise levels and lower sanding tem-
peratures than conventional sanding sheets.
Bosch Power Tools