Bosch GWS 18 V-LI Professional Originalbetriebsanleitung Seite 32

OBJ_BUCH-1102-002.book Page 33 Wednesday, November 4, 2009 3:23 PM
Cutting Metal
For cutting metal, always work with the pro-
tection guard for cutting 15.
When cutting, work with moderate feed, adapt-
ed to the material being cut. Do not exert pres-
sure onto the cutting disc, tilt or oscillate the
machine.
Do not reduce the speed of running down cut-
ting discs by applying sideward pressure.
Cutting Stone
For cutting stone, always work with the cut-
ting guide with dust extraction protection
guard 25.
The machine may be used only for dry cut-
ting/grinding.
For cutting stone, it is best to use a diamond
cutting disc. As a safety measure against jam-
ming, the cutting guide with dust extraction pro-
tection guard 25 must be used.
Operate the machine only with dust extraction
and additionally wear a dust protection mask.
The vacuum cleaner must be approved for the
extraction of masonry dust. Bosch provides suit-
able vacuum cleaners.
Bosch Power Tools
The machine must
For cutting expecially hard material, e. g., con-
always work in an
crete with high pebble content, the diamond
up-grinding mo-
cutting disc can overheat and become damaged
tion. Otherwise,
as a result. This is clearly indicated by circular
the danger exists
sparking, rotating with the diamond cutting
of it being pushed
disc.
uncontrolled out
In this case, interrupt the cutting process and al-
of the cut.
low the diamond cutting disc to cool by running
the machine for a short time at maximum speed
When cutting pro-
with no load.
files and square
bar, it is best to
Noticeable decreasing work progress and circu-
start at the small-
lar sparking are indications of a diamond cutting
est cross section.
disc that has become dull. Briefly cutting into
abrasive material (e. g. lime-sand brick) can re-
sharpen the disc again.
Information on Structures
Slots in structural walls are subject to the
Standard DIN 1053 Part 1, or country-specific
regulations.
These regulations are to be observed under all
circumstances. Before beginning work, consult
the responsible structural engineer, architect or
the construction supervisor.
Recommendations for Optimal Handling
of the Battery
Protect the battery against moisture and water.
Store the battery only within a temperature
range between 0 °C and 45 °C. As an example,
do not leave the battery in the car in summer.
Occasionally clean the venting slots of the bat-
tery using a soft, clean and dry brush.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.
English | 33
Switch on the ma-
chine and place
the front part of
the cutting guide
on the workpiece.
Slide the machine
with moderate
feed, adapted to
the material to be
worked.
1 609 929 U65 | (4.11.09)