Software Upgrade; Funk-Blitzauslöser - Hahnel Viper TTL Bedienungsanleitung

your devices
• A - Turn off both Viper TTL transmitter and receiver
• B - Hold down <Test> button
"transmitter". LED 06
05
button and LCD will display "coding"
• C - Now hold down receiver <Test> button
turn ON 12 "receiver". The LED
rapidly. Release <Test> button
change to red ON all the time confirming DCM is
completed
• D - If you have additional Viper TTL receivers, then
repeat stage "C". (Viper TTL transmitter must still be in
"coding")
• If you are using the Viper TTL in combination with the
hähnel Modus 600RT Speedlight, you can still DCM all
devices. Use the same procedure from A to D and then
also DCM match the Modus 600RT as a slave version as
explained in Modus manual
• It is possible to reset the Viper TTL transmitter and
receiver to "open channel"
• Hold down <Test> button
and continue to hold down button
06
LED will change from rapid flashing to always ON.
Transmitter is now "open channel"
• Now hold down receiver <Test> button
receiver and continue to hold down button
11
than 5 sec. LED will change from rapid flashing to
always ON. Receiver is now "open channel"
• If you wish to use old 3rd party Speedlight's which are not
E-TTL or i-TTL compatible, then set switch
"C" whilst performing the reset of the Receiver to "open
channel". This allows 3rd party Speedlight's to be triggered
in Speedlight "M" mode. Check our website www.hahnel.
ie for more info
Multiple Receivers & Flash Guns
• Additional Viper TTL receivers (i.e. Speedlights) can
be triggered wirelessly from the Viper TTL transmitter.
These additional receivers are available as an
accessory

Software Upgrade

• The micro USB socket
update the Viper TTL firmware if necessary. Go to
our website www.hahnel.ie for information on how to
download and update the firmware
• You will need a USB to Micro USB data cable for the
firmware update
• Use a Windows PC or laptop (not Apple IOS) to visit our
website to download and carry out the firmware update.
8
08 and turn ON
will flash rapidly, release the test
15 and
11 will flash green
15 . The LED 06 will
08
and turn ON transmitter
08
for more than 5 sec.
15
and turn ON
15
for more
16
to Group
09 and 13 can be used to
Viper TTL - English
Funk-Blitzauslöser
Bedienungsanleitung
Viper TTL - English
Funk-Blitzauslöser
1