Assembly Instructions; Safety Instructions; Installation Conditions - Ritter ET 10 Gebrauchs- Und Montageanleitung

ASSEMBLY INSTRUCTIONS

Unfold the illustrations (K to M)
at the back of this manual.

SAFETY INSTRUCTIONS

To avoid personal injury or
damage to the appliance,
please observe the following
safety instructions:
– This appliance may only
be assembled by qualified
personnel. ritterwerk will not
be held liable for the conse-
quences of improper and/or
incorrect assembly.
– The mains cable must be
positioned to ensure that
the appliance can be fully
folded down into the drawer
without trapping the cable.
The mains cable must be
routed directly and without
obstruction from the built-in
toaster system to the socket,
which must be mounted in
the floor unit.
– Unplug the cable from the
socket before assembly.
INSTALLATION
CONDITIONS
The following dimensions rep-
resent minimum values:
– Body width: 300 mm
– Clearance height for drawer
base/crossbeam: 75 mm
– Pullout clearance for front
edge of worktop/inner
edge of front drawer panel:
415 mm
– Clearance width (usable) for
drawer base: 184 mm
– Width of appliance (when
folded down): 178 mm
The drawer base should be at
least 16 mm thick.
At a nominal length of 500 mm,
the drawer's roller mechanism
should have a static load ca-
pacity of at least 40 kg.
For body widths exceeding
300 mm, it is possible to devi-
ate from the minimum lateral
distance of 53 mm and centre
the toaster laterally within the
drawer.
SELECTING A SOCKET
Note:
A Schuko (type F) socket
must be positioned at
drawer level on or behind the
drawer's rear panel.
The mains cable connection
to the socket should be routed
under the rear crossbeam or
the underside of the work top
and as high up as possible in
the corner of the floor cabinet's
rear panel.
It must be possible to slide the
drawer in fully while the mains
plug is in the socket.
The mains plug must be eas-
ily accessible to the user to
ensure that the appliance can
be unplugged from the mains
as required (for example, prior
to cleaning).
MOUNTING THE TOASTER
• Pull out the drawer until it
stops.
Place the drill template in
the drawer as shown in the
illustrations.
• Mark the positions for the six
drill­holes required.
• Use a 1 mm drill to pre-drill
the marked positions.
Use the six countersunk
screws provided (four 3 x 16,
two 4 x 13; for a drawer base
of 16 mm) to mount the holding
fixtures.
• Mount the toaster in the
drawer as described in the
operating instructions.
English
83