Clatronic LSM 2774 Bedienungsanleitung Seite 33

5....-05-LSM 2774
• Do not use any salts or strongly foaming additives in the bath!
• Do not move the device during operation. Do not pull the hose or the mains
lead of the motor device.
• Do not operate the motor device with wet hands or when you are in the bathtub.
• As additional protection the installation of a residual current device (RCD) with a
rated breaking current of not more than 30 mA is recommended in the electric
circuit of the bathroom. Please consult a qualified electrical engineer.
Description of the Operating Elements
1 Motor device
2 Infrared receiver
3 Time selector switch
4 POWER switch
5 Hose connection
6 Jet strength switch
7 Connection side for motor device
8 Connection side for whirlpool mat
9 Four-row jet operation
10 Hose connection and changeover switch for jet operation
11 Two-row jet operation
1. Remove the motor device and the accessories from the box. Also remove any
packaging materials that may be present.
2. Installing the motor device
The safety distance (see diagram) from the edge of the bathtub to the
motor device must be at least 60 centimetres!
Never place the device within this zone or above the bathtub!
The device must be at least 30 centimetres above the floor. Ideal surfaces
are non-upholstered chairs or stools. Do not use any supporting surfaces on rol-
lers, as these could be pulled towards the bathtub by mistake.
3. Wall Installation
The motor device can also be mounted on the wall. Please note the informati-
on given under section 2 above.
In order to mount the motor device on the wall, measure the distance between
the two indentations on the back of the motor device and then drill two holes
horizontally at this distance apart. Please ensure beforehand that you will not
damage any electric cables that are hidden in the wall! Then insert rawlplugs
and screws into the drilled holes. Then position the motor device over the scr-
ews and check that it is firmly in place.
4. Unfold the whirlpool mat and fix it to the floor of the bathtub. The hose connec-
tion must be facing the water outlet pipe.
5. Hose connection
The air hose has two ends of different colours (see diagram 3). Use the end
01.04.2003 16:25 Uhr
Preparations
Seite 33
33
GB