Clatronic ProfiCook DKI 3184 Bedienungsanleitung, Garantie Seite 57

ProfiC_BDA_DKP_3184_ka2.qxd
Always pull out the plug from the mains socket before cleaning and wait until the unit has
cooled down.
Do not use any wire brush or other abrasive objects.
Do not use any acidic or abrasive detergents.
Under no circumstances should the device be immersed in water for cleaning.
Ceramic Hob
• Clean the surface from food remains when it's still warm using a moist cloth or tissue.
• Wash the hob using a soft sponge and some water, then wipe dry with a soft cloth.
• Cleaning agent for ceramic surfaces: In case of stubborn, baked-in remains, use suita-
ble cleaning products available at special departments of department stores.
Housing
• Clean the housing after use using a slightly moist cloth.
• Make sure that no fluid matter gets into any of the openings of the housing. This might
damage the device or result in an electric shock.
• Device does not function, no indication on the display.
Remedy:
• There is a sound after I have selected a cooking function and switched the device
on.
Possible cause:
i
NOTE: For reasons of safety, the device automatically switches to the standby
mode after a few seconds.
Remedy:
• The hob suddenly switches off during operation.
Possible cause:
Remedy:
Further cause:
Remedy:
• When keeping food warm the pot is not maintaining the temperature.
Possible cause:
Remedy:
04.09.2007 14:33 Uhr
Cleaning
Troubleshooting
Check the mains connection.
You put no or an unsuitable pot on the hob.
Put a pot on the hob that is suitable for induction hobs.
The overheating protection (cutout switch) has been activated.
Pull the plug and let the device cool down for about 20 min.
Then start operating the device again.
The ventilation slots are obstructed.
Free the ventilation slots from any obstructions.
The pot's base is not level or bended (convex/concave).
Put a suitable pot on the hob.
Seite 57
GB
57