Casada BetaSonic Bedienungsanleitung Seite 16

Installation
3| INSTALL THE CONTROLLER HOLDER
1. Take the bracket for the remote control and position it on
2. The attachment device on the side panel can be found as
3. Insert the remote control into the holder.
4| INSPECTING THE ENTIRE MASSAGE CHAIR AND STRAIGHTENING OUT THE COVER
5| SETTING UP THE MASSAGE CHAIR
a) Remove the entire massage chair from
the base packaging and place it in a suit-
able position.
b) When setting up the massage chair, you
need to keep a distance of 5 – 10 cm
from the backrest to the wall and 50 cm
from the front, so that the backrest and
footrest can be freely tilted.
c) To avoid signal interference, please
place it one metre away from AV, TV,
and radio.
30
the outer side of the armrest.
shown. Use a screwdriver to fix the remote control holder
with the screws.
Installation
6| MOVING THE MASSAGE CHAIR
a) Hold the backrest with both hands as
shown on the right and tilt the massage
chair about 45° rearwards. Slide the mas-
sage chair carefully backwards or for-
wards on the castors until it is secured in
a suitable position.
NOTE:
Always move the chair with 2 persons and make sure that nobody sits on it.
•
By unnecessary displacement of the massage chair the floor can be damaged.
•
Hold on to the massage chair firmly to prevent it from falling down.
•
7| FLOOR PROTECTION
To avoid an uneven abrasion of your floor through the heavy massage chair, we recommend
placing a carpet or something similar underneath it.
CAUTION:
The massage chair should not be moved on sensitive floors, but should be carried by at least
two persons. Lift up the chair at the back and foot part. Doing this the foot part automatically
rises completely.
31