FoodSaver V1040 Anleitung Seite 4

HOW TO MAKE CUSTOM SIZED BAGS WITH THE
INTEGRATED BAG ROLL
1. Open Lid and place bag roll into roll storage
compartment.
2. Lift up Bag Cutter Bar.
3. Pull enough bag material from roll to hold item
to be vacuum packaged, plus 7.5 cm. Lower the
Bag Cutter Bar.
VS230 4/06
4. Cut desired bag length from Bag Roll. Make sure
to cut a straight line. Plug in Power Cord.
5. Open the Lid. Place one end of the cut bag
VS230 4/06
between the Sealing Strip and the Lower Sealing
Gasket. DO NOT place open end of bag in the
Drip Tray.
6. Close Lid. Position hands on both sides of the
VS230 4/06
Lid. Press firmly on both sides of the Lid and
hold until the motor starts.
4 www.foodsavereurope.com
VS230 4/06
NOTE: Sealer will not operate if Lid is not
properly closed.
7. Continue to hold the Lid. When the Hands-free
Indicator Light illuminates, it is safe to remove
your hands from the Lid. The Sealing Indicator
Light illuminates when the unit starts sealing
the bag.
8. When the motor stops and the Progress
Indicator Lights shut off, sealing is complete.
9. Press the Open/Cancel button.
VS230 4/06
10. The custom sized bag is ready for vacuum
VS230 4/06
sealing.
NOTE: The Open/Cancel button can be used to
cancel the process mid-cycle and open the Lid. The
bag will not be sealed when doing this.
CAUTION: This sealer is not for commercial use. If
sealing more than 30 bags in a row wait at least 25
minutes before continuing to use your vacuum food
sealer.
CAUTION: The unit has a cool down period between
cycles. Wait 20 seconds before using again.
HOW TO VACUUM SEAL WITH FoodSaver
1. Place the items to be sealed into a pre-cut or
custom sized bag. Leave at least 7.5 cm
between the contents and the top of the bag to
allow for bag contraction.
2. Open the Lid and place the open end of the bag
into the Drip Tray.
VS230 4/06
3. Close Lid.
4. Change Press to Select the appropriate Seal
Level – Choose Moist for foods with high liquid
content or Regular for dry foods.
VS230 4/06
5. To begin the vacuum process, press down firmly
on Lid with both hands and hold until the motor
starts. Continue to hold the Lid. When the
Hands-free Indicator Light illuminates, it is safe
to remove hands from the Lid. The unit
continues to vacuum and seal the bag.
VS230 4/06
www.foodsavereurope.com
BAGS
®
6. When the motor stops and the Progress
Indicator Lights shut off, sealing is complete.
7. Press the Open/Cancel button.
VS230 4/06
8. Lift the Lid and remove the bag.
NOTE: The Open/Cancel button can be used to
cancel the process mid-cycle and open the lid. The
bag will not be sealed when doing this.
CAUTION: This sealer is not for commercial use. If
sealing more than 30 bags in a row wait at least 25
minutes before continuing to use your vacuum food
sealer.
CAUTION: The unit has a cool down period between
cycles. Wait 20 seconds before using again.
5