Location Of Controls; Intended Use; Unpack Device - BOMANN Multi Express ME 466 CB Bedienungsanleitung, Garantie

WARNING: Risk of injury!
• Appliances can be used by persons with reduced physical, sen-
sory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of
the appliance in a safe way and if they understand the hazards
involved.
WARNING:
• The cutting, grating, and rasping inserts are very sharp on the cut-
ting or rasping surfaces! When fitting and removing the inserts and
during cleaning you will come into contact with these accessories.
Use these accessories with the necessary caution to prevent inju-
ries. Only touch the inserts on the plastic.
• Always only use the pusher to press down the food and not your
fingers, a fork or other objects.

Location of Controls

1 Pusher
2 Feed neck
3 Insert holder
4 Dark green insert for chopping coarsely
5 Light-green insert for chopping finely
6 Yellow insert for grating
7 Orange insert for rasping finely
8 Red insert for rasping coarsely
9 Motor block
10 On / Off switch
Not shown.
Tool for disassembling the inserts

Intended Use

This appliance serves for the cutting, rasping or grating of solid
food.
It is only designed for this use and should only be used for this
intended purpose.
It is not designed for chopping meat or frozen foods or food
that is too hard such as nutmeg and cooking chocolate, for
example.
Only use this device as instructed in this user manual. Do not
use this device commercially.
26
No other use is intended and can cause damage or personal
injuries.
The manufacturer is not responsible for any damages incurred
due to improper use.

Unpack Device

1. Take the device out of its packaging.
2. Remove all packaging materials, such as foils, filling mate-
rials, cable ties and cartons.
3. Check that all accessories are included in the box.
4. If the contents of the box are incomplete or if damage is
found, do not operate the appliance. Return it to the dealer
immediately.
NOTE:
Clean manufacturing residues and dust from the device as
described under "Cleaning".
Instructions for use
Assembly / Preparations
1. Place the appliance on an even work surface.
2. Install the insert holder (3) onto the motor block (9) by twist-
ing it anticlockwise.