Storage; Cleaning And Care - Beem DYNAMIC i-POWER Bedienungsanleitung

DYNAMIC i-POWER
Restarting after interruption
When you let go of the handle (6) dur-
‹
ing ironing, the appliance switches
itself off (automatic safety switch-off,
fig. B) and the control indicator (11)
flashes.
If you wish to continue ironing after
‹
an interruption, grip the handle (6)
firmly: the control indicator (11) and
the temperature indicators (9) will light
up on both sides. The appliance starts
heating to attain the previously set
temperature. When the temperature
has been reached, the temperature
indicators extinguish. The control indi-
cator (11) lights up again until you let
go of the handle. It then begins flash-
ing again.
After using
Set the temperature regulator (13) to
‹
the "OFF" position.
Pull the plug out of the mains socket.
‹
Open the tank lid.
‹
Hold the appliance over a wash basin
‹
or similar and turn it upside down. The
water will now run out of the tank.
Empty the water tank each time after
‹
using the appliance.
Clean the appliance as described in
‹
the Cleaning and care section.
26

Storage

If you do not intend to use the appliance
for a longer period of time, clean it as de-
scribed in the Cleaning and care section.
Allow the appliance to cool down com-
pletely before storing.
Store the appliance in an upright position,
not on the ironing sole.
Store the appliance and all accessory
parts at a dry, clean and frost-free loca-
tion, which is protected against direct
sunlight.

Cleaning and care

Before beginning work, pay attention to
the safety instructions in the section on
safety!
Ironing sole
■ Clean the ironing sole with a soft damp
cloth. Subsequently wipe with a soft
dry cloth.
Self-cleaning function
Self-cleaning function
Regularly perform (at least after every
10 hours of use) the following work steps
described.
Turn the steam flow regulator (3) to
‹
position 0.
Set the temperature regulator (13) to
‹
the "OFF" position.
Pull the plug out of the mains socket.
‹
BEEM - Elements of Lifestyle
EN