Spray Function - Beem DYNAMIC i-POWER Bedienungsanleitung

EN
Upright steam ironing
NOTE
► Upright steam ironing is suitable for
hanging textiles (coats, suits, cur-
tains) and for removing creases.
► Only hang the washing to be ironed
where heat and humidity cannot
cause damage, NOT in front of
wallpaper, windows or mirrors for
example.
► The appliance produces turbo steam
for upright steam ironing. This has a
separate pipe and is only discharged
from the front part of the ironing sole.
If necessary, fill the appliance with wa-
‹
ter (Filling with water section).
During heating up, make sure that
‹
the appliance is placed upright on an
even surface.
Insert the plug of the appliance into
‹
the mains socket. The control indica-
tor (11) light ups.
Turn the temperature regulator (13) to
‹
the "MAX" position.
The temperature indicators (9) light up
on both sides of the appliance during
heat-up.
Hold the appliance upright with a gap
‹
of 5 to 15 cm in front of the fabric to
be ironed and press the steam shot
button (4) every 2 to 5 seconds.
Move the ironing sole up and down in
front of the fabric.
If steam is no longer discharged, wait
‹
for a few seconds until the appliance
produces new steam.
BEEM - Elements of Lifestyle
NOTE
► The lower the temperature set, the
less steam is discharged from the
appliance and the longer the inter-
vals until steam is generated again.
Press the steam shot button (4) to dis-
‹
charge a steam shot.
button at intervals of a few seconds.

Spray function

NOTE
► The spraying function is ideally suit-
ed for moistening stubborn creases
in cotton or linen.
Press the button (5)
‹
appliance discharges a spray shot.
.
DYNAMIC i-POWER
Steam shot
. Press the
so that the
25