Care And Maintenance - VALERA Ceramix Pro 626 Serie Bedienungsanleitung

LONGER STYLES
• Use the same method, starting from the neck and working upwards, followed
by the sides and then the top of the head.
• To adjust the cutting length, use the barber's comb (fig.7), or else your fingers
to help (fig.8), using the appliance without a guide comb.
• The appliance comes supplied with a set of clips (fig.1 - ref.12) for sectioning
very long hair and for cutting fringes.

CARE AND MAINTENANCE

• The cleaning and maintenance procedure must be carried out after every use.
• All maintenance or blade change operations must be carried out with the
appliance switched OFF and removed from the charger.
• Never immerse the appliance in water!
• After every use, remove the guide comb then use the small brush to elimina-
te any hair from the cutting head and its seat.
• Clean the outside of the appliance with a soft cloth (slightly damp if neces-
sary). Never use solvents or abrasive detergents!
• Remove the cutting head (fig.9) and evenly oil the seat of the motor pin which
is located on the inside.
• If after prolonged use, and despite regular cleaning and lubrication, the cut-
ting ability of the appliance appears to be diminished, the cutting head must
be replaced.
• Once the appliance has been cleaned, the guide comb can be fitted back in
place since it also helps to protect the blade.
• Do not oil the ceramic blade set.
DISPOSAL
• Dispose of the appliance in accordance with all regulations governing waste
disposal and the safeguarding of the environment.
This appliance complies with the Directive on Electromagnetic -compati-
bility 89/336/CEE and the Low Voltage Directive 73/23/CEE.
6