VALERA Ceramix Pro 626 Serie Bedienungsanleitung Seite 6

CUTTING WITH GUIDE COMBS
Depending on the type of cut desired, the appliance can be used with or without
a guide comb. The guide combs can be adjusted to 13 different settings by
means of the comb setting selector (fig.1 - ref.19) in order to allow different cut-
ting lengths. The setting is visible on the comb setting reference (fig.1 - ref.18).
Without a guide comb, the appliance has a cutting length of 1 mm.
FITTING AND REMOVING THE GUIDE COMB
• Switch the appliance off.
• Use the bottom button of the comb setting selector (fig.1 - ref.19) to retract
the guide comb fully (fig.2) to setting 1, shown on the comb setting reference
(fig.1 - ref.18).
• Grip the comb and pull as indicated in (fig.3) to remove it.
• To replace the comb, again with the appliance switched off and the selector
to setting 1, fit the comb in the guide and click it into place (fig.4).
CERAMIC BLADE SET
The ceramic blade set guarantees a perfect hair cut for long time without oiling.
CHANGING BLADES
• Switch the appliance off.
• To remove a blade, push to release from the seat as shown in (fig.9).
• To refit a blade, follow the instructions in (fig.10): first insert the rear section in
the seat (A), then push the front to secure in place (B).
STYLING TIPS
SHORT STYLES
• Choose the guide comb and, using the selector (fig.1 ref.19), adjust it to the
best setting for the desired length of cut. We advise you begin from a higher
setting and then move on to a lower setting as required.
• Cut hair while dry, using short strokes and progressing slowly.
• Comb the hair as you proceed in order to remove cut hair and check the
results.
• NECK: Starting from the midpoint of the bottom of the neck (fig.5) work
upwards using short strokes towards the middle of the head (fig.6), gradually
working outwards to the sides.
• SIDES: We advise you use a lower setting, working in the same way as with
the neck.
To finish sideburns and the area around the ears, use the appliance without a
guide comb, holding it turned downwards.
• TOP OF HEAD: Use a higher setting. Start from the forehead working
backwards towards the middle of the head.
5