SUNWARE 20 serie Bedienungsanleitung Seite 15

1 Foreword
Congratulations!
You have purchased a high-quality solar module from SunWare
Solartechnik and thus have opted for the highest quality
"made in Germany".
To enable you to enjoy your new solar module for as long
as possible, please read the following information carefully.
If this does not answer any queries you may have sufficiently,
please contact your specialist dealer in the first instance.
Of course, we are also very happy to help as much as we
can.
Direct information is available at www.sunware.de
Content:
1 x Solar module
1 x Installation manual
10 x white screw collars
Only by modules with 3 wired connection cable:
1 x Cell protector (including:)
1 x Housing
1 x PCB-Board
2 x pcs. of strain relief clamp
4 x pcs. of screws with pressed washer
(for the strain relief), 3,0 x 14 mm
2 x pcs. of screws (for the box),
3,0 x 16 mm for the housing
Please note!
The cell protector is attached to the box liner next to the module.
13
2 Important information
This user manual provides important safety instructions that you
should read carefully and follow.
Please retain your original invoice and the original packaging at
least for the period of the warranty.
Do not, under any circumstances, open the watertight cable
connection box and do not drill any additional holes (e.g. for
a special type of fixing) into your solar module.
SunWare solar modules are not flexible!
The modules can be slightly bent for mounting - a maximum of
3 cm per 1 m of module length!
Module length of 1m
Solar modules can be bent a maximum of 3%
In particular, please make sure that the module cannot swing!
Swinging and overbending can damage or destroy the module!
Always use all the fixing points of the module!
It has to be taken care of a strain relief of the cable and that the
cable is not bent too much!
E
3 cm max.
14