Philips RQ1195 Gebrauchsanleitung Seite 58

english
58
Problem
The shav-
er does not
work when I
press the on/off
button.
RQ1195 only:
The shaver is
not entirely
clean after
I clean it in
the Jet Clean
System.
Possible cause
Speciic types only: The Jet Clean
System has not cleaned the
shaver properly, because the
cleaning luid in the cleaning
chamber is soiled or the cleaning
luid level is too low.
The rechargeable battery is
empty.
Speciic types only: The travel
lock is activated.
The shaving head holder is
soiled or damaged to such an
extent that the motor cannot
run.
The temperature of the shaver
is too high. In this case, the
shaver does not work.
The cleaning luid in the clean-
ing chamber is soiled.
The cleaning luid level is too
low. If the luid volume in the
cleaning chamber drops below
the minimum level during the
cleaning program, the program
aborts.The cleaning light and
the 'cleaning chamber empty'
symbol lash at intervals and
the holder returns to its start-
ing position.
Solution
Clean the shaver thoroughly
before you continue shaving.
If necessary, clean and reill the
cleaning chamber (see chapter
'Cleaning and maintenance').
Recharge the battery (see chapter
'Charging').
Press the on/off button for 3
seconds to deactivate the travel
lock.
Clean the shaving head holder or
replace it (see chapters 'Cleaning
and maintenance' and 'Replace-
ment').
Let the shaver cool down. As
soon as the temperature of the
shaver has dropped suficiently,
you can switch on the shaver
again.
Empty and rinse the cleaning
chamber and reill it with new
cleaning luid.
Reill the cleaning chamber with
cleaning luid to a level between
the two lines (see chapter 'Clean-
ing and maintenance').