Connecting The Headphones With The Transmitter; Storing And Transporting The Headphone System; Fault Removal - Blaupunkt Comfort 112 Wireless Bedienungsanleitung

Connecting the headphones with the transmitter

Headphones and transmitter are already connected with each other in the delivery state.
If you want to use diff erent headphones at the transmitter, you must connected these
headphones with the transmitter.
u Switch on the audio device connected with the transmitter and start the music play-
back.
u Switch on the transmitter with the
The power-on indicator of the transmitter lights blue.
u On the transmitter, hold the ID button pressed for 3 seconds with the tip of a
ball-point pen.
The power-on indicator of the transmitter fl ashes quickly.
u Switch on the headphones with the
The power-on indicator of the headphones fl ashes slowly.
u On the headphones, hold the PAIR button pressed for 3 seconds.
The power-on indicator of the headphones now fl ashes quickly.
After a few seconds, the headphones are automatically connected with the transmit-
ter and both power-on indicators light.

Storing and transporting the headphone system

You can store the headphones, the transmitter and the accessories in a space-saving
way using the supplied transport case and transport it safely. For this purpose, the head-
phones are quipped with rotating earpieces.
u Rotate the earpieces by 90° before placing the headphones in the transport case.
Note:
The earpieces can be rotated in one direction only. Rotating in the wrong direction
may damage the headphones.
20
button.
button.

Fault removal

Sound interferences occur or no sound can be heard
•
The battery in the transmitter is too weak and must be charged.
•
Replace spent batteries in the headphones with new ones.
•
Check the cable and plug connections between transmitter and audio source. Ensure
that all devices are switched on and the music playback is not interrupted.
•
If the volume level at the audio source is set too low, the sound quality may be im-
paired due to noise. Increase the volume of the audio source. If the sound is distorted,
reduce the volume of the audio source.
•
Change the volume at the headphones.
•
Adjust the headphone band so that the ear cushions completely surround the ears.
•
Reduce the distance between transmitter and headphones. The greater the distance,
the higher the risk of sound interferences.
•
The sound signal can be impaired through metal objects. Remove obstacles between
headphones and transmitter or change your location.
The power-on indicator at the transmitter fl ashes or does not light
•
The battery is too weak and must be charged.
•
Check the cable and plug connections to ensure that the audio source is properly
connected.
•
Ensure that the transmitter and the audio source are switched on and the music play-
back is activated.
•
The transmitter automatically switches off after a 10-minute interruption of the sound
signal. Start the music playback and switch the transmitter back on.
The power-on indicator at the headphones fl ashes or does not light
•
Replace spent batteries with new ones.
•
Check the cable and plug connections between transmitter and audio source. Ensure
that all devices are switched on and the music playback is not interrupted.
•
Ensure that the distance between headphones and transmitter is less than 30 metres.
Check the setting on the LO/HI switch for the range. The reception can be impaired
through metal objects, even at a shorter distance.
•
The connection between headphones and transmitter is impaired. Switch the head-
phones off and on again.
•
The headphones are not correctly paired with the transmitter. Adjust the frequency
of the headphones to the frequency of the transmitter.
21