Lighting - Gesipa AccuBird Pro Betriebsanleitung

3 beeps and flashing LED lights for 10 seconds:
The battery needs to be changed soon (about 20% battery charge remaining).
6 beeps and flashing LED lights for 10 seconds after every setting sequence: Change
the battery after a few more riveting sequences in order to guarantee safe riveting sequences
(approx. 10% battery remaining).
9 beeps and flashing LED lights for 10 seconds: The next riveting sequence cannot be
reliably carried out. The blind riveting tool is switched off. Change the battery.
1.8

Lighting

The blind riveting tool is equipped with 3 LED lights to illuminate the work space. These can
be turned on by turning the black ring (n° 57) behind the LEDs. There are 3 settings, which
are displayed by an arrow cast in the housing.
— Continuous light/torch function:
The lighting is switched on after a riveting sequence and stays on for
approx. 10 minutes. The LEDs then turn off automatically.
•
Lights switched off.
-- Work light:
Lights are switched on at the start of the riveting sequence. The LEDs stay
on for about 10 seconds and then switch off automatically.
Zero position:
GB
23