Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Kurzanleitung / Quick installation guide
SNC-5312IR, SNC-5315IR, SNC-5323IR
IP camera SNC-5312IR, SNC-5315IR and SNC-5323IR
ATTENTION!
Please do not open the camera housing.
All connections and settings are accessible from the outside.
The camera is equipped with a motorised DC vario lens and is adjusted via the web
interface (focus, zoom).
Improper handling will invalidate the warranty!
To operate the IP camera, please follow these steps:
1. Connect the
power/PoE/alarm/audio cables
from the ceiling or wall to the
corresponding connectors of the
camera. Connect the camera to
power using PoE (PoE switch or
PoE injector required) or 12 V DC /
24 V AC.
2. If required, open the lid on the bottom of the housing. Here you will find the additional
video test connector, the reset button and the micro SD card slot.
3. In the desired installation location, mount the camera using suitable screws.
4. Use the included torx wrench to loosen the bracket screws a bit to adjust the camera
into the right position. If you are satisfied with the camera position, tighten the bracket
screws again.
5. Sunshield:
Ensure to correctly install the sunshield.
6. Insert the CD (included in the delivery) into your PC/laptop and install the IP-finder.
7. The IP-finder displays an IP address for the camera. Double-click on the IP address
and the Internet Explorer comes up automatically. In case this doesn't work, you may
also enter the IP address (as shown by the IP-finder) manually into the Internet
Explorer. Using the IP-finder, another IP address can be assigned to the camera, if
required.
IP address:
The camera comes with a default IP address:
Default IP address:
User name:
Pass word:
Please refer to the user manual for further installation information and on camera
configurations.
Subject to technical changes. Errors excepted.
QUICK INSTALLATION GUIDE
192.168.1.168 (or by DHCP, if available)
admin
9999
Version 1.1sfi/0914/dt-engl/A5
Werbung
