tepro 8591 Bedienungsanleitung Seite 2

t
Safety instructions
• Danger Risk of Injury! The meat clamps are very sharp. Proceed with particular caution when skewering the meat for roasting.
• Danger Risk of Electric Shock! The spit motor must be protected from water or steam and must not be used in the rain.
• The plug of the spit motor must be connected to the mains supply via a fused power socket.
• Connection via a permanently installed cable is not permitted.
• Do not use the device if it or the mains cable show signs of damage or if the device has been dropped.
Intended Use
This roasting spit serves for the holding of meat for roasting, such as poultry or joints. The roasting spit is intended for private use only. Only use the item as
described in this operating manual. All other uses are considered improper and can lead to material damage or even to personal injuries. The manufacturer
accepts no liability for damages caused by improper use.
Before first use
Wash off possible coarse production residues using warm water. In doing so, avoid the use of cleaning agents or detergents.
Assembly
1. Install the motor mount (G) with the aid of the included screws onto the
fire bowl.
2. Fasten the motor (F) onto the motor mount (G).
3. Screw the handle (E), segment (B) with roll ring (D), and segment (A)
together.
Please note: Segment (B) is optional, depending on the size of the BBQ
being used. Should you only require segment (A), the roll ring (D) must
be fit to the end of this segment.
4. Stick one meat clamp (C), the meat for roasting, and then the second
meat clamp (C) onto the spit. Make sure the meat is as evenly distributed
as possible, in order to reduce the load on the motor.
5. Clamp the meat for roasting between the meat clamps (C) and fix these
in place using the holding screws on the roasting spit.
6. Guide the roasting spit with tip (A) into the motor driving opening and
then lay it on the supports.
7. The roll ring (D) serves as a guide and must be placed with the notch on
the edge of the fire bowl.
8. Connect the mains adaptor of the motor (F) to a suitable socket.
9. To switch the motor on and off, use the toggle switch on the side of the
motor.
Cleaning
1. A ttention: Do not submerge the motor (F) in water or other liquids!
Wipe down the housing with a damp cloth, as necessary. Make sure that
no moisture gets inside the housing.
2. Clean the roasting spit and the meat clamps thoroughly with warm water
and a little detergent after each use.
3. Dry off all the parts thoroughly after cleaning.
Disposal
Do not under any circumstances dispose of the device in normal
household waste! Dispose of it at an approved disposal business
or at your community disposal facility. Respect the currently valid
regulations. If in doubt, get in touch with your disposal facility.
Technical details
Item: No. 8591, Universal Roasting Spit Set
Power: 4 W, 220-240V~, 50 Hz
suitable for tepro gas BBQ:
Calverton 3147, Wellington 3135, Keansburg 3149
P150363_TEPRO_8591_Grillspiep_A4_20151126.indb 1
Universal Roasting Spit Set
Operating manual
F
Service
This product was carefully manufactured and packaged. Should you
nevertheless have a complaint, our employees are more than happy to assist.
For service questions, you can reach us at the following email address
(distributor).
Subject to technical modifications and typographical errors.
Distributor
tepro Garten GmbH
Carl-Zeiss-Straße 8/4
D-63322 Rödermark
Email: info@tepro-gmbh.de or
backoffice@tepro-gmbh.de
Web: www.tepro-gmbh.de
A A
C
A Roasting spit
segment
G
B Roasting spit
segment
C Meat clamps
Item No. 8591
Version 2015
E
B
D
D Roll ring
E Handle
F Motor with
mains plug
G Motor mount
3/12/15 3:46 PM