Setting The Speed - WOLFF Vario-Stripper SILENT 230 V Betriebsanleitung

5.1 Hand clutch
The hand clutch is located in front of the handle of the machine.
Engage the motor drive by pushing the clutch forward / down.
By pulling the clutch upwards the Vario-Stripper SILENT stops.
Do not run the machine for a long while (e.g. during a break) with
the motor drive switched on and the clutch disengaged.
After changing the inclination of the handle, it may be necessary
to readjust the handle attachment of the clutch. See also
Chapter 5.4 "Adjusting the handle".

5.2 Setting the speed

To adapt the Vario-Stripper SILENT to different floorings, adjust
the speed. The optimum speed depends on the type of flooring,
the adhesive and the ambient temperature.
Therefore generally valid statements cannot be given.
If the blade jumps on top of the flooring, reduce the speed.
5.3 Setting the angle of the blade
The blade angle can be varied with three different angle
adapters. The stripper is delivered with the 15° angle adapter
mounted. The angles of the two other adapters are 25° and 35°.
Optimum angle of the blade
The optimum angle of the blade depends on the type of flooring,
the adhesive and the subfloor.
Due to the variety of working conditions generally valid state-
ments cannot be given.
If the blade jumps on top of the flooring, set the angle steeper.
Set the angle flat with soft subfloors like particle boards or wood.
Otherwise you might deteriorate the subfloor.
03/2006 Vario-Stripper SILENT , Artikel-Nr. 038764Fu
(pic. 3)
(pic. 1)
(pic. 2)
Blade holder
Abweiser Blech
Hexagon bolt
Sechskantmutter
Replacement
Ersatzmesser
blade
Flachrundschraube
Screw
mit Vierkantansatz
machine truss
Blechschwinger
Striker Foot
Casting
angle
Winkeladapter 15°
adapter
Sechskantmutter
Hexagon nut
Flachrundschraube
Screw
mit Vierkantansatz
machine truss
13