Important Safeguards; Service And Repairs - Cleanfix Homecleaner Bedienungsanleitung

3.3. Attach the spray hose trigger by
sliding it along the grooves on the
handle.
4. Remove waste water container. Fill
machine with clean warm water
and cleaning agent upto the central
stem. It is clearly marked. Fit the
waste water tube to the connecting
point.
Caution ! Do not pour water or cleaning agents into the central stem suction tube!
6. Press vacuum and pump switches.
To spray the cleaning solution
squeeze the control trigger on the
handle.
7. Before using the Homecleaner as a carpet extractor check that the carpet is colour fast. Apply a small amount of the diluted
solution to a normally hidden section of the carpet with a clean white cloth. Any non-fast dye will show on the cloth.
8. To operate as a carpet extractor
a. Start at the corner furthest from the door. When you press the trigger the cleaning solution is sprayed into the carpet fibre.
The vacuum sucks back the soiled water into the waste water tank.
b. Whilst pressing the trigger, slowly draw the spray nozzle towards yourself. Release spray trigger, lift the nozzle of the
carpet and start with the next line slightly overlapping the previous line cleaned.
c. For best results, move the nozzle slowly over the carpet. Repeat each action without the trigger to remove all the soiled
solution and help dry the carpet quicker. For heavily soiled areas use a recommended pre-cleaner. Spray the effected
area before normal carpet extraction.
d. If the unit is not spraying any cleaning solution onto the carpet, the tank needs refilling. Turn off the unit immediately.
Empty waste water container, rinse and refill in order to continue.
9. When the carpet has been cleaned switch off both switches. Empty the unit, fill up with clean water and rinse though hoses
and accessories by switching on the pump switch and spraying the solution into a sink or a toilet. At the end empty the unit
and dry thoroughly.
10. Before removing the spray hose release any pressure in the system by operating the trigger. To remove the spray hose
press back the plastic collar of the connector.
Normally the carpet is dry enough to walk on after approximately 4 to 6 hours. You can reduce the drying time by opening
windows to improve ventilation. Avoid walking on damp carpet and allow to dry before replacing furniture. In case furniture has to

7. Important safeguards

•
Read and follow instructions!
•
Do not pull on the electrical supply cable to remove the plug from the socket!
•
Do not vacuum oil or inflammable materials or liquids!
•
Avoid vacuuming hard or sharp objects. They damage hose, cleaner and dustbag!
•
Use only recommednded cleaning agents!
•
Do not overfill the machine or use foaming agents!

8. Service and repairs

•
Let repairs only be executed by authorised service agents!
•
Never work on any electrical componant by yourselves!
•
During cleaning of the machine make sure the unit is un-plugged!
3.4. Attach the spray hose to the hose
with the clips provided.
5. Replace the waste water tank and
pour a teaspoon full of defoamer
into the tank. This will help reduce
foaming, should it occur. Replace
the transparent cover.
7. For hardfloor cleaning slide the
hardfloor adaption into the lower
grooves of the suction nozzle.