Herunterladen Inhalt Inhalt Diese Seite drucken

Kalibrierung - LuxaFlex PowerView Bedienungs- Und Programmieranleitung

Vorschau ausblenden Andere Handbücher für PowerView:
Inhaltsverzeichnis

Werbung

2. KALIBRIERUNG

Die Kalibrierung lässt die Anlage ein paar Mal auf- und abbewegen,
um die Endlagen festzulegen.
2.1 Halten Sie die Motortaste für ca. sechs Sekunden lang gedrückt.
2.2 Lassen Sie die Motortaste los.
2.3 Die obere und untere Schiene stoppen in der untersten Position.
84
Watch out to perform steps 2.4 and 2.5 within 3 seconds!
2.4
Press and hold the manual control button
2.6
.
2.2
Release the manual control button .
depending on the product the shade will start
moving up and down several times defining
new open and close positions.
2.5
Press the
open button.
2.3
The blind will finish with both top and bottom
rail at the bottom position.
Page 6 of 18
2.6
Release the manual control button .
3. Moving / checking the blind.
This instruction will make use of the following buttons
on the Remote:
Page 6 of 18
Release the manual control button .
Die Anlage wird sich einmal
kurz nach sechs Sekunden
bewegen.
The blind will jog 1x
The blind will jog 1x
2.1
2.2
Die Anlage wird sich ein
paar Mal auf und ab
bewegen um die offenen
und geschlossenen
Positionen zu definieren.
2.3

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis