Achtung:
Die folgenden zwei Schritte müssen innerhalb von drei Sekunden
durchgeführt werden !
5.6 Halten Sie die Motortaste gedrückt.
5.7 Drücken Sie die rechte Pfeiltaste.
5.8 Lassen Sie die Motortaste los.
5.9 Wenn die Tasten der Fernbedienung noch blinken, ist die Fernbedienung noch im
Programmiermodus. Halten Sie dann die STOP-Taste sechs Sekunden lang gedrückt,
damit sie den Programmiermodus verlässt.
Anmerkung:
Die Fernbedienung wird den Programmiermodus automatisch
nach 20 Sekunden verlassen.
5.10 Die „Durchsicht"-Position ist jetzt eingestellt !
58
The next 2 steps need to be performed within 3 seconds!
5.6
Press and hold the
5.7
manual control button
5.8
5.8
Release the
manual control button
5.8
Release the
manual control button
5.7
Press the
button.
arrow up
5.9
Press and hold the
button for 6 seconds.
5.9
stop
Note: The remote will exit programming mode
automatically after 20 seconds.
5.10
The slat open position is set!
5.9
Press and hold the
Page 15 of 20
5.10
stop
Note: The remote will exit programming mode
automatically after 20 seconds.
6. Clearing slat open position (Twist™ only)
Keep pressing until the remote lights start
blinking
Press the
.
button.
arrow up
Release the
manual control button
.
.
Press and hold the
button for 6 seconds.
stop
Note: The remote will exit programming mode
automatically after 20 seconds.
Keep pressing until the remote lights stop
The shade will jog 1x to acknowledge the
blinking
slat open position is set
button for 6 seconds.
The slat open position is set!
PowerView™ EOS® 500 Rollerblind/Twist™ programming with Rem
SLAT OPEN
Keep pressing until the remote lights stop
blinking
5.6
5.7
.
Die Anlage wird sich
einmal kurz bewegen,
um anzuzeigen, dass die
The shade will jog 1x to acknowledge the
„Durchsicht"-Position
slat open position is set
eingestellt ist.
5.8
5.9
Halten Sie die Taste
gedrückt, bis die Lichter der
Fernbedienung aufhören
Keep pressing until the remote lights stop
zu blinken.
blinking
5.10
SLAT OPEN