Alarm Function (In Standby Mode) - AEG MRC 4142 Bedienungsanleitung, Garantie

Setting the time (in standby)
1. Keep the /SLEEP button (2) pressed for a short time. The time indicator begins to
flash.
2. Set the hours with the /H button (6) and the minutes with the /M button (9).
NOTE:
If you do not press a button within 4 seconds, the settings are automatically accepted.
SLEEP (Delayed switch-off) (2)
When the device is switched on, you can set the time after which the device will turn into
standby mode; set the time in 10 minutes intervals from 90 to 10 minutes. The device will
turn off automatically after the preset time.
1. Press the button. The notification "90" will appear in the display.
2. Press the button repeatedly to reduce the time in steps of 10. The "OFF" setting
deactivates the function.
To call up the still remaining time, press the button briefly.

Alarm function (in standby mode)

Setting of the Alarm
You can set two alarm times. Proceed as follows:
1. Keep the /VOL- button pressed for approx. 3 seconds. The indicator begins to flash.
2. Set the hours with the /H button (6) and the minutes with the /M button (9).
3. Press the /VOL- button to confirm. Then select how you want to be awakened.
Perform the adjustments with /M and /H buttons and confirm them with the
VOL- button. Select from:
• bu (Buzzer):
A buzzer sounds when the alarm time is reached. The volume of the buzzer cannot
be adjusted.
• Last heard radio frequency:
As soon as your set alarm time is shown, the radio switches on. The last tuned sta-
tion plays at the last set volume.
4. Finally, press the
To set the second alarm time, repeat the above steps with the
/VOL- button again. The first alarm time is now activated.
English
51
/
/VOL+ button (3).