Ferm JSM1014 Übersetzung Der Originalbetriebsanleitung Seite 7

7. Saw shoe
8. Locking bolt for parallel guide
9. Dust extraction connection
10. Grip
11. Allen key
12. Allen key holder
ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Mounting and removing the saw blade (fig. B)
Refer to the table below to select the required saw
blade.
Saw blade
Coarse
Medium
Fine
Very fine
Do not attempt to remove the guard from
the machine.
Mounting
• Slacken the Allen screw (13) using the Allen
key (11).
• Insert the saw blade (14) in the saw blade
holder (6) as far as possible. The teeth of
the saw blade (14) must point upward and
forward. The smooth side of the saw blade
must engage in the slot of the guide roller (15).
• Tighten the Allen screw (13) using the Allen key
(11).
Removing
• Slacken the Allen screw (13) using the Allen
key (11).
• Remove the saw blade (14) from the saw blade
holder (6).
• Tighten the Allen screw (13) using the Allen key
(11).
Mounting and removing the parallel guide
(fig. C)
The parallel guide is used for sawing along edges
at a maximum distance of 16 cm.
Mounting
• Slacken the locking bolts (8).
• Insert the parallel guide (16) into the saw shoe (7).
• Set the parallel guide (16) to the required
• Tighten the locking bolts (8).
Removing
• Slacken the locking bolts (8).
• Remove the parallel guide (16) from the saw
• Tighten the locking bolts (8).
USE
Switching on and off (fig. A)
• To switch on the machine, press the on/off
Material
Wood
• To switch the machine to continuous mode,
Wood
Steel, aluminium, plastic
Wood (curves)
• To switch off the machine, release the on/off
Setting the sawing speed (fig. A)
The speed adjustment wheel is used for setting
the sawing speed. The speed adjustment wheel
can be set to 6 positions. The ideal sawing speed
depends on the profile and the teeth of the saw
blade and on the material to be worked.
• Turn the speed adjustment wheel (3) to the
• For hard materials, use a saw blade with fine
• For soft materials, use a saw blade with coarse
Setting the mitre angle (fig. D)
The mitre angle is variable between 0° and 45°.
• Slacken the Allen screws (17) using the Allen
• Tilt the saw shoe (7) to the required position.
position.
shoe (7).
switch (1).
keep the on/off switch (1) pressed and
simultaneously press the lock-on button (2).
switch (1).
Do not set the sawing speed during use.
required position.
teeth and select a lower speed.
teeth and select a higher speed.
Do not set the mitre angle during use.
key (11).
7