auga Compact C Bedienungsanleitung Seite 20

Persons who have not read and understood the operating instructions
should not use the pump!
This device is not intended for use by persons or children with impaired physical,
sensory or intellectual impairments, or if lacking in experience and/or know-how,
unless they are under supervision or have been trained in the use of the device
by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the device.
Design:

Efficient, multifunctional pump with a 6-pole, 3-phase, brush-free
permanent magnetic motor with high efficiency and long lifespan.

Pump axle and bearings made of top quality ceramics for resistance to
wear-and-tear.

Motor made of poured synthetic resin (IP 68)
Uses:
Compact C pumps are suitable for transporting fresh water, without chemical
additives, for circulation filter systems, ornamental waterways, waterfalls,
fountains and water ornaments.

Before carrying out any work to the pump and/or pond or other system
to which the pump is connected, remove the pump plug from the
electrical socket and other other connected devices.

Do not use the pump when there are people in the water! (Isolate the
pump from the mains network).
Uses: garden ponds, fish ponds, fountains, patio fountains (see figures
1+2+3)

Caution: May only be used in garden ponds and the corresponding
protection zone if the installation fulfils the prevailing guidelines. In the
event of any doubts, please consult an electrician.

For technical information on the pump, see the nameplate or the
table on page 2.

Before carrying out any work to the pump and/or pond or other system
to which the pump is connected, remove the pump plug from the
electrical socket and other connected devices.

Do not use the pump when there are people in the water! (Isolate the
pump from the mains network).

Observe the safety instructions.
Safety instructions

Warning! This pump may only be used if the electrical system meets
relevant statutory requirements.
If in doubt, consult a qualified installer.

The pump may only be connected to a system with a ground-fault
circuit interrupter (30mA) and earthed power outlet.

The mains voltage and current type must match the information on the
nameplate or table on page 2.

Place the power outlet in a moisture-free area, at least 2m from the
water's edge (see image 1+3.)
English
www.auga.nl 20