Setting The Pendulum Action; Switching On/Off; Operating Tips - Cocraft LXC JS18 Original Bedienungsanleitung

Setting the pendulum action

The adjustable pendulum action can be adapted to the workpiece material being sawed.
Turn the selector (4) to the desired setting.
- Position 0: Sheet metal, steel, hard plastic or rubber (no pendulum action)
- Position 1: Non-ferrous metals, hardwood, hard plastic
- Position 2: Wood
- Position 3: Soft wood (largest pendulum action for greatest stock removal)

Switching on/off

1. Slide the battery into the grooves of the battery
connection on the bottom of the handle making
sure that it clicks securely into place.
2. Hold in the trigger safety catch on either
the right or left side. When the safety catch is in
the middle position, the trigger is locked.
3. Pull the trigger to switch the saw on. Release
the safety catch and adjust the blade speed
using the trigger.
4. Turn the saw off by releasing the power trigger.

Operating tips

Preparations
• Measure and mark out the sawing line carefully before starting to cut.
• Small workpieces should be securely clamped.
• Check that the footplate is locked at the required angle before you begin sawing.
• If you are unsure about the choice of blade speed or type of blade, test-cut a piece
of scrap of the same material as the workpiece.
Sawing
• Hold the jigsaw in a firm grip. Make sure that the saw blade is not in contact with
the workpiece and then pull the trigger to start the saw. Let the motor come up to
speed before starting to cut.
• Never apply excessive forward pressure to the tool – always let the blade do the work.
• Keep hands in sight, do not hold hands under the workpiece where the blade
cannot be seen.
9