Install The Hardware - Axis P3301-V Installationsanleitung

AXIS P3301/P3304 Installation Guide

Install the hardware

!
IMPORTANT! - The casing of the AXIS P3301-V/AXIS P3304-V is not approved for
outdoor use - the product may only be installed in indoor environments.
Mount the camera
The AXIS P3301/P3304 can be mounted with the cables routed through the wall/ceiling, or from
above or below. There are cover plates for the openings on both sides of the dome cover.
The AXIS P3301/P3304 can also be fitted with a metal conduit for protecting the cabling when
connected via the side openings. See the illustrations on page 4.
1. Using the drill template, drill two holes in the ceiling/wall. Ensure the camera is positioned so
that the tamper-proof screws can be tightened using the supplied screwdriver.
2. Route the required cables. See Connect the cables, on page 6 for details.
3. Fasten the camera unit to a ceiling or wall, using screws and plugs appropriate for the ceiling/
wall material.
4. Proceed to Connect the cables, on page 6.
Mounting on a drop ceiling
To mount the AXIS P3301/P3304 on a drop ceiling, check that the ceiling material is sturdy enough
to hold the weight of the camera.
The camera can also be secured using a plate or board that better carries the weight of the camera,
and which is more suitable for securing the screws.
The AXIS P3301/P3304 network camera can also be mounted using the Drop Ceiling Mount, which
allows the camera to be mounted more discreetly. Please see www.axis.com for all available
mounting accessories.
Plate or board
Ceiling
AXIS P3301/AXIS P3304
Screws
Page 5