BADU BADUJET Primavera Originalbetriebsanleitung Seite 84

Installation
Mounting the main housing in a concrete pool
NOTICE
Only tighten the screws hand-tight. Do not use any force!
1. Position the top outlet connection (B) above the inlet
connection (C).
2. Installation depth: The middle of the main housing/nozzles
should be mounted 30 cm under the water level.
3. Insert the nub seal (26) in the housing (1).
4. Align the main housing (1) and fasten it to the formwork with
4 tapping screws (103).
5. Press the round sealing cord into the housing groove.
6. The dummy plate (30), with the four tapping screws (103), is
used to protect the housing during plastering and as a cover
in the case of commissioning the swimming pool without the
final assembly kit being installed.
 Please observe the installation sketch.
Mounting the main housing in a concrete pool with foil
lining (A)
 Observe 5.2.3: Aligning the support ring
34 106 (B)
105 (C)
Fig. 7
22 EN
1
103
30
26
103 4x 6x22
52 12x 6x40
A
27
70
28
WG23.140.041-P
01|2018
52