Maintenance & Care; Disposal Of Batteries - Bissell 1311 SERIES Handbuch

Maintenance & Care
Brush roll reset:
If larger debris becomes lodged in the foot of
the unit and the brush roll shuts off, turn the unit
off and remove the obstruction. Wait approxi-
mately 15 seconds for the motor to cool down
before turning back on. Brush will function again
after allowing time to cool down.

Disposal of Batteries

If your MultiReach Ion Series is to be disposed of,
the batteries should be removed and disposed
of properly.
1. IMPORTANT: Unplug Charger and discharge
the unit completely.
2. Remove hand vac from unit and remove
dirt cup from handle.
3. Remove (2) Phillips head screws and
remove the lens from the hand vacuum.
4. Remove (2) Phillips head screws from
the hand vacuum cover.
5. Lift off the hand vacuum cover.
6. Take out push rod.
7. Remove (5) Phillips head screws from
the side of the hand vacuum.
8. Remove the entire battery assembly from
the cover.
9. Cut wires from the PCB and wrap the
wire ends with insulation tape.
10. Keep Battery Pack together – DO NOT
separate individual batteries. For specific
disposal instructions of batteries, please
follow local regulations.
11. Hand in remainder of product at an official
collection point for recycling.
CAUTION
Disconnecting the battery will destroy the appliance and
invalidate the warranty.
7.
5 screws
WARNING
DO NOT ABUSE BATTERY. DISPOSE OF BATTERY
PROPERLY.
www.BISSELL.com
9