Hama Magic Color Bedienungsanleitung Seite 15

Holding down either button will change the
increment unit rapidly. Press [MODE] button to
confi rm.
7. The °C/ °F digits will fl ash. Press [
button to switch between °C (Centigrade) and
°F (Fahrenheit) temperature format, and then
press [MODE] button to confi rm.
Note: If no key press during setting mode for
10 seconds, it will automatically keep the
setting and exit to normal display.
SET THE DAILY ALARM
1. In Alarm time display mode, press & hold
[MODE] button for 2 seconds, the hour digits
will fl ash. Use the [
your desired alarm hours, then the minute
digits will fl ash. Use the [
to set your desired alarm minutes. Holding
down either button will change the increment
unit rapidly. Press [MODE] button to confi rm.
2. In alarm time display mode, press [
once to toggle between enable or disable the
daily alarm.
3. When alarm is beeping, press any button will
stop it except the [SNOOZE-LIGHT] button.
Press the [SNOOZE-LIGHT] button will stop
alarm sound temporary for 5 minutes.
HOW TO READ INDOOR/OUTDOOR
TEMPERATURE
1. When it displays the indoor temperature (not
Auto-scrolling), press [CH] button once to
switch to channel 1 and display the channel
1 temperature, press [CH] button again will
switch to next channel. The sequences are:
Indoor Channel 1
Channel 3
(repeat).
2. In Auto-scroll mode, the upper LCD will
alternately display indoor temperature and the
registered remote temperatures for 4 seconds.
14
00092658bda.indd Abs1:14 00092658bda.indd Abs1:14
] or [ ]
] or [ ] button to set
] or [ ] button
] button
Channel 2
Auto-Scrolling
Note: Only registered remote channel(s) will
be shown up in the Auto-scroll mode and
unregistered channel(s) will be skipped. The
"--._°C" or "--._°F" will display to prompt
the user for a RF loss link in a specifi c sensor
channel.
3. When received indoor temperature is over
+60 °C (+140.0 °F) or outdoor temperature is
over +70 °C (+158.0 °F), "HH.H" will appear
on the upper LCD. When received indoor
temperature is below -10 °C (+14.0 °F) or
outdoor temperature is below -50 °C (-58.0 °F),
"LL.L" will appear on the upper LCD.
HOW TO SET ALERT LIGHT ON INDOOR/
CHANNEL 1
Press & hold [ALERT] button for 2 seconds to
enter Alert Light setting mode. Press [
[ ] button to select Alert Light monitor
according to Indoor temperature or Channel 1
temperature. Press [ALERT] to confi rm.
Note: The channel 1 Alert light is available only if
the channel 1 has been registered successfully.
1. While the Alert lighting color is set to monitor
indoor temperature, the color of Alert light
and LCD backlight will change according to
temperature as in Table 1.
] or
25.11.09 09:14 25.11.09 09:14