Aesculap GT 104 Gebrauchsanweisung Seite 8

¾
The cutter head can cut properly only if there are no
hairs between the cutter blades.
¾
Tighten the knurled screw only so far that the upper
cutter blade can still be moved with moderate pres-
sure from the side.
¾
Cutter heads are changed while the machine is run-
ning. To do this, the lever on the side of the ma-
chine must be pressed.
¾
To maintain the accuracy of cutting over a longer
period, a heavily soiled coat of the animal to be
sheared should be cleaned beforehand.
¾
To ensure trouble-free cutting, it is advisable to
comb the animal thoroughly and to untangle mat-
ted parts.
¾
The cutter heads can be professionally sharpened
several times. For this purpose, contact an
authorized repair shop:
Aesculap Suhl GmbH
Fröhliche-Mann-Straße 15
98528 Suhl / Germany
Phone: +49 3681 49820
Fax: +49 3681 498234
E-mail: suhl@aesculap.de
5. Storing
Keep the clipper in a dry place with oiled cutter heads
and cutter head holder.
6
6. Important spares
When ordering spare parts please indicate the serial
number as well as the type of the clipper 20 (Fig. 1) to-
gether with the cataloque number of the spare re-
quired.
GT 604 Special oil for cutter heads
GT 605 Special gear grease
GT 104 614 Carbon 24
GT 104 803 Airfilter 4 (Favorita/Elektra)
GT 104 808 Oscillating lever 22
GT 104 244 Plastic sliding bar 23
GH 214 813 Airfilter 4 (EHMANN)
TA 004 662 Knurled screw 11
TA 004 663 Cylinder screw 14 for fixing pres-
sure plate 15 at the lower cutter
blade
GT 730 203 Plate spring 12
GT 730 201 Pressure plate of plastic 15