Renkforce GM107 Bedienungsanleitung Seite 31

Setting the DMX starting address
• Press MODE/ESC (1) repeatedly until Addr appears.
• Push the button ENTER (4) until Axxx (xxx = set DMX start address) appears.
• Use the buttons UP (2) or DOWN (3) to select the desired DMX starting address.
• Press the ENTER button (4) to confirm your input.
The following tables provide information about the effects of the settings on the individual DMX channels.
5-channel DMX operation
DMX channel DMX value
1 000-255
2 000-255
3 000-255
4 000
001-255
5 000
001-255
12-channel DMX operation
DMX channel DMX value
1 000-255
2 000-255
3 000-255
4 000-255
5 000-255
6 000
001-255
7 000-255
8 000-255
9 000-255
10 000
001-255
11 000
001-084
085-169
170-255
12 000-254
255
Function
Rotating movement PAN
Swivel movement TILT
Speed for PAN and TILT fast > slow
No strobe effect
Strobe effect slow > fast
Light off
Colour selection
Function
Rotating movement PAN
Fine setting rotating movement PAN
Swivel movement TILT
Fine setting swivel movement TILT
Speed for PAN and TILT fast > slow
No strobe effect
Strobe effect slow > fast
Brightness red (0 % > 100 %)
Brightness green (0 % > 100 %)
Brightness blue (0 % > 100 %)
Channels 7-9 are active
Colour selection (Channels 7-9 are deactivated)
Channels 1-11 are active
Automatic mode slow (Channels 1-11 are deactivated)
Automatic mode fast (Channels 1-11 are deactivated)
Sound-to-Light Mode (Channels 1-11 are deactivated)
no function
Reset
31