Dmx Connection; Connection Of A Dmx Controller - Renkforce GM107 Bedienungsanleitung

• The light effect can be set up or installed with the enclosed mounting bracket.
• If you do not want to use the device standing but mount it on a suitable traverse system, attach the effect
light with the included mounting bracket and a suitable traverse clamp that is available separately.
• For this, use the mounting bracket to install the two screws at the bottom plate and attach the light effect
to the traverse system with a suitable traverse clamp. Use only assembly material suitable for the type of
assembly and for bearing the effect light load.
• The assembly must never swing freely.
• Additionally secure the installation with a suitable safety restraint cable or a safety net.
If you use a safety catching rope, screw the enclosed ring screw into the floor plate of the effect light and
attach the safety catching rope there.
The safety retention rope or the net must be designed to support the effect light in the event of failure of
the main support system independently of the main attachment.
• Make sure that the projector head of the light effect beamer can move freely; it may not hit onto anything
or be blocked.

9. DMX Connection

You can operate a maximum of 32 devices in a DMX chain without overloading the controller.
The maximum total length of the DMX chain should not exceed 500 m.
Use of XLR microphone cables may cause interferences in the DMX signal transmission. In this
case, please use special DMX high-frequency cables.
a) Connection of a DMX Controller
Only connect the device to a DMX controller with a DMX-512 protocol.
• Connect the connection INPUT with the output of the DMX controller.
• Use a screened XLR cable for this. The controller must have up to 5 or 12 free control channels depen-
ding on DMX operating mode.
• Connect OUTPUT with the DMX input of the subsequent device.
27