B) Setting Up A Master-Slave Chain - Renkforce GM107 Bedienungsanleitung

• If the effect light is the last or the only device in the DMX chain, insert a plug with a 120 ohm/0.25 W
terminating resistor into the OUTPUT socket (between Pin2 and Pin3).
Pin assignment of the DMX connection: Pin1 = earth / Pin2 = (-) / Pin3 = (+).

b) Setting up a Master-Slave Chain

In master-slave mode, up to 16 devices can be controlled by the master device, since the inter-
nal controller of the master device will otherwise be overloaded.
The effect light can be operated controlled by a DMX controller or in a master-slave chain. In that case, the
integrated controller of the master device controls the connected slave devices.
• Connect the OUTPUT port of the master device to the INPUT port of the first slave device.
• Connect the OUTPUT port of the first slave device to the INPUT port of the next slave device.
• Proceed as described above with all remaining slave devices.
• Plug an XLR plug with a terminating resistor into the OUTPUT connection of the last slave device (as
described in section „Connection of a DMX controller").
28