Zenner MinoConnectRadio Bedienungsanleitung Seite 5

States and actions
For a better view, but also for the diagnosis and possibly error detection in a system, MinoConnect shows the most important
states and actions with 7 coloured LED:
LED Function
TxD Indicates that a data transmission from MinoConnect to the connected device is being carried out
RxD Indicates that data are being sent from the connected device to MinoConnect
3.3V 3.3 Volt are available at the pin for the external supply voltage
7V 7 Volt are available at the pin for the external supply voltage
lights after power-on, the power LED signals by different flash frequencies the following modes:
Blink interval
■
2.4 seconds
Power
■
0.6 seconds
■
0.12 seconds
Charge Charging light. With a connected supply it lights until the batteries are fully charged.
The flashing Bluetooth LED displays that the device is paired with another Bluetooth device (*).
Bluetooth
The constantly lighting LED displays, that the device is connected with another Bluetooth device.
(*) Note: The flashing is only visible after a power cycle.
Disposal
This device contains non removable and non-rechargeable
batteries (must be verified depending on the product).
Batteries contain substances, which could harm the environ-
ment and might endanger human health if not disposed of
properly.
To reduce the disposal quantity so as unavoidable pollutants
from electrical and electronic equipment in waste, old equip-
ment should be reused prior or materials recycled or reused
as an other form.
This is only possible if old equipment, which contains bat-
teries or other accessories are disposed. Therefore please
contact the department of your local authority which is res-
ponsible for waste disposal. Alternatively a waste disposal
via ZENNER is possible.
Your local or municipal authority or the local waste dispo-
sal company can give you information relating the collection
points for your used equipments.
ZENNER International GmbH & Co. KG
Römerstadt 6
D-66121 Saarbrücken
State
⇒
Bluetooth connection is established
⇒
No Bluetooth connection
⇒
Battery capacity low, reload immediately! This display also occurs when a connected device requires too much
power (for example: short circuit).
Telephone +49 681 99 676-30
Telefax +49 681 99 676-3100
Attention
Do not dispose of the devices with domestic waste.
In this way, you will help to protect natural resources and to
promote the sustainable reuse of material resources.
For any question, please contact
The most up-to-date information about this product and of our
installation notice can be found at
E-Mail info@zenner.com
Internet www.zenner.com
Remarks
-
-
for ex. MinoHead
for ex. ZENNER Optical head
info@zenner.com
www.zenner.com.
5