Technical Data; Noise & Vibration - Pattfield PE-108 BS Originalbetriebsanleitung

REPLACEMENTS
The grinding wheels should be replaced when
it's not possible to keep a distance of 2 mm to
the work rest or 2 mm to the eye shield. The
wheels and their accessories are available at
any Hornbach store.

Technical Data

Nominal voltage
Rated power
Wet wheel size
Wet wheel speed
Dry wheel size
Dry wheel speed
Sound pressure level (L
Maximum wear of wheel allowed:
Wet wheel
Dry wheel
Weight
Degree of protection
The values given are valid for a nominal voltage of 230 V. For lower voltage and models for
specific countries, these values may vary.
Please observe the article number on the type plate of the tool.
Noise
The values given in these instructions have
been measured in accordance with a stand-
ardized measurement procedure specified in
EN 61029 and can be used to compare tools.
It may be used for a preliminary assessment
of exposure.
88 EN
230 V / ~50 Hz
250 W (intermittent operation: 30min)
200 mm x 40 mm x 20 mm bore
134 min
150 mm x 20 mm x 12.7 mm bore
2950 min
) <70dB(A)
pA
150 mm
100 mm
10.7 kg
IP23
Caution! Make sure the replace-
ment wheels match the require-
ments stated in the technical data on the
next page!
-1
-1