Product Overview; Using The Tool; Intended Use; Before Use - Pattfield PE-108 BS Originalbetriebsanleitung

Product overview

1 Wet grinding wheel
2 Wet grinder work rest
3
Water bath securing screws (3x)
4
Water bath
5 Drive spindle
6 Product label
7 PRCD mains plug
8 Mounting holes (one at each corner)
9 PRCD plug controls
10 ON/OFF switch
11 Wheel guard securing bolts (3x)
12 Work rest
13
Wheel guard
14
Grinding wheel
15 Eye shield
16 Drain plug for water bath

INTENDED USE

The tool is intended for wet and dry grinding.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.

BEFORE USE

1 Secure the grinder through the mount-
ing holes 8
nuts or bolts (not included).
3 Mount the mounting bracket to the
grinding wheel guard 13.
86 EN
to a bench with screws,

Using the tool

1. Press switch 10
to ON position (I).
2. Dry grinding: Use the grinding wheel 14.
Put the work piece on the work rest
and hold it to the rotating wheel.
3. Wet grinding: After initially filling the
water bath 4 let the wet grinding wheel
1 rotate for approx. 1 minute. Check the
water level and refill if required. Put the
work piece on the wet grinder work rest
and hold it to the rotating wheel. After use
drain water bath immediately.
4. To switch off the tool, press switch
OFF position (0).
Warning! After switching OFF, the
wheels continue to rotate for some
time.
2 Attach the work rest 12. Adjust the gap
between work rest and grinding wheel
14
to 3 mm.
3 Fit the eye shield
bracket as close as possible to the
grinding wheel 14
contact with it.
12
2
10
to
15 to the mounting
without coming into