Bosch GTA 600 Professional Originalbetriebsanleitung Seite 10

OBJ_BUCH-1382-001.book Page 10 Thursday, January 13, 2011 9:15 AM
10 | English
Product Features
The numbering of the product features refers to
the illustration of the saw stand on the graphics
pages.
1 Tension latch
2 Retaining clamp
3 Base frame
4 Saw stand leg
5 Fastening kit
6 Housing frame (GTS 10 J Professional)
7 Strike (GTS 10 J Professional)
Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Assembly
Delivery Scope
Please also observe the represen-
tation of the delivery scope at the
beginning of the operating instruc-
tions.
Before assembling the saw stand, check if all
parts listed below are provided:
– Base frame 3
– Saw stand legs 4 (4 pcs.)
– Fastening kit 5 consisting of:
Phillips screws M8 x 45 (4 pcs.),
Lock nuts M8 (4 pcs.)
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
– Open-end spanner (13 mm)
Assembling the Saw Stand
(see figures A1 A2)
–
– Carefully remove all parts included in the de-
livery from their packaging.
– Remove all packaging material.
– Undo tension latch 1 and pull the base frame
3 apart.
1 609 929 X94 | (13.1.11)
– Insert the saw stand legs 4 into the square
tubing of base frame 3 until the mounting
holes are aligned.
The saw stand legs must face outward.
– Screw the saw stand legs and the base frame
together with the screws and nuts of fasten-
ing kit 5.
Fastening the Power Tool
(see figures B1 B3)
–
– Tilt both retaining clamps 2 upward.
– Slide the rear housing frame 6 of the power
tool completely into the retaining clamps 2.
– Centre the power tool on the base frame.
– Hang the clip of tension latch 1 over strike 7
and fold down the latch to lock the power
tool in place.
Operation
Working Advice
Do not overload the saw stand. Always observe
the maximum carrying capacity of the saw
stand.
Always hold the workpiece firmly, especially the
longer and more heavy section. After cutting
through the workpiece, the centre of gravity
may become dislocated in such an unfavourable
manner that the saw stand tips over.
Transport (see figures C1
When folding the saw stand together or
apart, the power tool may not be mounted
to the saw stand.
The saw stand can be folded together for trans-
port.
– Remove the power tool.
– Fold both retaining clamps 2 down.
– Fold the saw stand together.
– Hang the clip of tension latch 1 over the oth-
er side of base frame 3 and fold down the
latch to lock the saw stand.
C3)
–
Bosch Power Tools