Geberit AquaClean Sela Inbetriebnahme Seite 8

EN
2
Check the status of the heating element of
the storage water heater: LED on control
panel lights up blue, heating element is set
to user detection (economy mode)
(factory setting).
The spray nozzle is automatically cleaned
before and after each shower procedure.
3
Press the shower button on the control
panel: The spray arm is extended, the
shower starts.
4
Increase or decrease the spray intensity by
pressing the < – > / < + > buttons.
5
Wait 3 min. Press shower button again and
check whether shower water is at body
temperature.
Result
All functions of the control panel have been
checked.
8
ºC
If the storage or transport temperature
exceeds 45 °C, the thermal cut-out will be
tripped.
6
If water is cold, reset thermal cut-out.
T 20
2
1
1
B1127-001 © 09-2013
966.494.00.0 (00)