Bodypack Transmitter Connection
Lavalier Microphone Connection:
Connect the connecter of supplied lavalier
microphone to the connecting jack of trans-
mitter (see picture). Set the transmitter work
state in wireless lavalier system.
Headsat Microphone Connection:
Connact the connactor of supplied headset
microphone to the connecting jack of trans-
mitter (see picture). Set the transmitter work
state in wirelass headset system.
Guitar Cabla Connection:
Connect the connactor of supplied guitar ca-
ble to the connecting jack of transmitter and
the other connector to guitar (see picture). Set
the transmitter work state in wireless guitar
system (G).
Tips to achieve optimum performance
• Be sure you always can see one of the receiving antennas of the transmitting position.
• Keep the distance from transmitter to receiver as short as possible.
• Bring the reception antennas into an angle of 45 ° from the vertical.
• Make sure that the receiving antenna is not located near metal surfaces.
• Pay attention to the level of the batteries and replace the batteries if the red light turns on.
• If you use the receiver on a rack or a conditioning system, make sure that antennas do not touch.
• Before a demonstration or presentation make a test tour. If there are anx spots with bad reception,
change the location of the receiver. If there are still spots with bad reception, mark and dodge them.
13