For The First Time; Instruction For Use; Mincing Meat - Hendi 210864 Gebrauchsanweisung

• This appliance is not intended for use by persons(including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the ap-
pliance by a person responsible for their safety
• Children should be supervised to ensure that they do not play with the appliance.
• Do not operate this appliance if the cord or plug is damaged. Return it to the store
of service or repair by professional serviceman.

4. FOR THE FIRST TIME

• Check that voltage indicated on the rating label
corresponds the mains voltage in your home.
• Wash other parts except body(motor housing) in
warm soapy water.

5. INSTRUCTION FOR USE

5.1. ASSEMBLING
• Due to unintended starting up of the KS100E
EN
• Place grinder/feeder head tightly into attach-
ment opening (fi g.1). Holding head with one
hand, place locking knob into the hole on the side
of the motor housing and tighten knob by turning
clockwise (fi g.2).
• Place the snake into the head, long end fi rst, and
turn to feed the screw slightly until it is set into
the motor housing (fi g.3).
• Place the cutting blade onto the snake shaft with
the blade facing the front as illustrated (fi g.4). If
it is not fi tted properly, meat will not be grinded.

5.2. MINCING MEAT

• Cut all foods into pieces (Sinewless, boneless
and fatless meat is recommended, approximate
size: 20 mm x 20 mm x 60 mm) so that they fi t
easily into the hopper opening.
• When cutting the meat, press small switch in the
back "ON" position, and then press "ON" on the
front panel.
6
• Wash all parts (except body) in warm soapy water.
• Before plug in, make sure the key switch in the
"OFF" position, that is the natural state of all
keys.
• Place the desired cutting plate next to the cutting
blade, fi tting protrusions in the slot (fi g.5).
• Support or press the centre of the cutting plate
with one fi nger then screw the fi xing ring tight
with another hand (fi g.6). Do not over tighten.
• Place the hopper plate on the head and fi x it into
position.
• Locate the unit on a fi rm place.
• The air passage at the bottom and the side of
the motor housing should be kept free and not
blocked.
MUST MAKE SURE THAT BOTH "ON" POSITION,
THEN THE MEAT GRINDER START TO WORK.
• Feed foods into the hopper plate. Use for it only
the food pusher (fi g.7)
• After using, Press"O"to let appliance to stop,
then pull plug out.