Safety Instructions - Elektro-Automatik EL 9000 A Bedienungsanleitung

General
About
Elektro-Automatik GmbH & Co. KG
Helmholtzstrasse 31-33
41747 Viersen
Germany
Phone: +49 2162 / 37850
Fax: +49 2162 / 16230
Web: www.elektroautomatik.de
Mail: ea1974@elektroautomatik.de
© Elektro-Automatik
Reprint, duplication or partly, wrong use of this instruction
manual are prohibited and might be followed by legal
consequences.
Instruction Manual
EL 9000 A Series
Safety instructions
• Only operate the device at a mains voltage as stipulated
on the type plate!
• Never insert mechanical parts, especially from metal,
through the air ventilation slots!
• Avoid any use of liquids of any kind in the proximity of
the device, they might get into it!
• Do not connect voltage sources to the device which are
able to generate voltages higher than 100V
del) or 180V (160V model) or 460V
DC
• In order to equip interface cards into the slot at the
rear, the common ESD provisions have to be followed!
• The interface card may only be plugged and unplugged
while the unit is completely switched off (mains switch
OFF)!
• Always observe limit and nominal values of the device
when connecting a voltage source or battery, as well
as when using the analogue interface!
• For safety and stability reasons, power cables should
not exceed a length of 2m and should be twisted!
• The DC input is not fused!
Date: 11-16-2011
EN
(80V mo-
DC
(400V model)!
DC
27