How To Use - JVC HA-W500RF Bedienungsanleitung

HOW TO USE

1. Connect the transmitter and AV equipment. (Refer to page 9)
2. Connect the AC adaptor to the transmitter, then plug the AC adaptor into an
AC outlet. (Refer to page 10)
3. Turn on the power on the transmitter and the connected AV equipment.
Transmitter power
When an audio signal is input, the transmitter's power is turned on automatically, and the
indicator lights in green. Also, when no audio signal is input for about a minute, the
indicator goes out automatically and the power turns off. (Automatic Power On/Off function)
The Automatic Power On/Off function is activated from audio on the left channel. The
function may not activate properly in situations when the audio signal is detected only from
the right channel.
In some situations, the power may not be turned on automatically by the input sound
(e.g. a song with a quiet opening or gradual fade-in). This is not a malfunction.
4. Turn on the headphones' power. To avoid excessive volume, first set the
headphones' volume to a low level.
Before using the headphones for the first time, charge the rechargeable Ni-Cd battery.
14
HOW TO USE
5. Adjust the volume control of the connected AV equipment and the
headphones, and set them to the desired listening level.
6. Turn the TUNING control to get the best reception in the headphones.
In cases of interference or too much noise, select the CHANNEL switch on
the transmitter to another position, then repeat step 6.
To set optimum signal reception, adjustments
should be done within a range of approx. 7 m
between the transmitter and the headphones.
Within approx. 7 m
MAX. MIN.
Tips for better use
For improved sound quality, set the volume level of the connected equipment as high as
possible without causing distortion, while setting the volume level of the headphones to a
slightly lower level.
After use
Keep the headphones' power off.
Notes:
1. When using the headphones, don't raise the volume excessively. Continuous listening
for a long time at high volumes may damage your hearing.
2. For safety reasons, do not use the headphones while riding a bicycle or driving a
motorcycle, car, etc.
VOL.
15