Mounting / Integration To A Harness - Independence Annular Classic 20 Betriebsanleitung

3. Close the upper and lower flap with the pins. Remove the
packing cords then!
5. To avoid an unintentional opening, the German type
approval (LTF) prescribe a minimum release-force of 20 N.
If the system does not have this minimum release-force, it is
necessary to build in a predetermined breaking point
(special thread). This have to define a minimum release
force of 20 N.
The special thread which is used as predetermined
breaking point must be put through the hole of the pin and
around the loop as shown on the picture.
Both ends of this special thread are fixed with a knot and an
additional seal.
To secure the pin it is only allowed to use certified material
because if the strength of this material is too high the save
operation of the rescue system is not guaranteed.
This thread is supplied by Fly market GmbH & Co. KG! Do
not use other threads which may look the same!

18. Mounting / integration to a harness

For harnesses without integrated rescue-container:
If the harness does not have an integrated rescue-container you can use the outercontainer which is shown at point 17.
This outercontainer shown at point 17 has got several loops, eyelets and velcro-tapes on it´s back side to attach it at the
harness. The possibilities of the attachment to the harness depends on the harness. For a correct mounting you have to
read the manual of the harness.
Usage of a frontal-container / outercontainer of an other manufacturer.
The possible usage of a frontal-container or of an outercontainer of an other manufacturer depends on the size and if the
container is certified. If the container is too small or not certified the operating license of the rescue-parachute expires. If it
is a container of an other manufacturer you have to read the manual of the container. For attaching it to the harness you
have to read the manual of the harness.
For harnesses with integrated rescue-container:
Almost all modern harnesses have an intergrated rescue-container in which a rescue-parachute can be placed. For the
correct mounting of the rescue-parachute in such a container you have to read the manual of the harness.
4. Close the upper flap finally. Notice the packing in the
"repack and inspection log book".