Flash Power Control - STUDIOTECHNIK MONO MAX 750 Bedienungsanleitung

user manual MONO MAX
Radio Flash Trigger
and Power Control
System RC/RF
8:
TEST
15,16:
34
The slave is an impulse photocell. It can only operate, when
the triggering flash has a higher f-stop than the ambient light.
Please be aware that the ambient light which strikes the slave
may never be too strong. If this cannot be avoided, please
switch off the slave and release the flash by cable or radio
signal.
Synchronization by Radio Control System
For all units of the MONO MAX series the HENSEL Radio
Flash Trigger System RC/RF is available as accessory (set,
transmitter and receiver). The remote control allows for flash
triggering via radio signal.
Radio Flash Trigger and Power Control System RC/RF,
Set, transmitter and receiver,
For operation with MONO MAX units the radio receiver is
attached to one of the sync sockets 2 of the compact flash.
The radio transmitter is attached to the camera using the
synchronization cable or by mounting it onto the Hot Shoe of
the camera. Four channels can be selected. The selected
channel of the transmitter and receiver must correspond to
each other. Flashes can be triggered by pressing the TEST
button of the transmitter or by releasing the camera shutter.
Before starting up read and comply carefully the instruction
manual of the Radio Control System.
Test flash
By pressing the push-button 8 of the front panel or of the
Cable Remote Control RC-X (accessory, Code No. 3310) test
flashes can be released.

Flash power control

The desired flash power can be set in 1/10 f-stop increments
using power control 15. This covers a range of 6 f-stops (1/1
to 1/32). The flash output will be shown on the two digits 7-
segment display 16.
When operating with the Cable Remote Control RC-X
(accessory, Code No. 3310) the flash output can only be
adjusted in 2/10 f-stop increments.
In case of reducing the flash power, the stored energy will be
discharged by APD-system (Automatic Power Drop). No flash
will be triggered.
Power output over 6 f-stops:
MONO MAX 3000:
MONO MAX 1500:
MONO MAX 750:
Code: 387
3000 J : 93,8 J
1500 J : 46,8 J
750 J : 23,4 J
HENSEL Studiotechnik